cancel
Showing results for 
Search instead for 
Did you mean: 

The new crate motor by EV West and Revolt fits just like a small-block Chevy

One of the biggest hurdles to EV swaps has been for builders to construct a driveline that can withstand the capable torque of an electric motor, along with the big question of how to mount it in between the frame rails. The solution for a while has been to make custom motor plates under the hood from which that the motor can hang. Then, building a drive adapter to match a motor's output shaft with a driveshaft yoke usually involves spinning off custom-machined parts, which is both expensive and raises the barrier of entry.

 

Read the full article on Hagerty.com: https://www.hagerty.com/media/news/the-new-crate-motor-by-ev-west-and-revolt-fits-just-like-a-small-...

View Entire Topic

No thank you, I'll stick with my SBC!

Pit Crew